Woodworking engraving machine and laser engraving machine

Woodworking engraving machine uses: solid wood doors, paint-free doors, all wood furniture carving, cutting, panel furniture, audio, screen, advertising industry, etc. are applicable. If you are a long person, you can also mass-produce it. If you compare it with the manual, the machine will have the advantage, the speed, and the accuracy. The next order will be exactly the same. You just need to wait for the staff to change the materials.
Woodworking engraving machine uses: solid wood doors, paint-free doors, all wood furniture carving, cutting, panel furniture, audio, screen, advertising industry, etc. are applicable. If you are a long person, you can also mass-produce it. If you compare it with the manual, the machine will have the advantage, the speed, and the accuracy. The next order will be exactly the same. You just need to wait for the staff to change the materials.
Laser machines are generally used for crafts, cutting acrylic, carved crystal characters, shells, coconut shells, horns, lampshades and other small handicrafts. It is not that the things carved out by the laser machine are smooth, but what materials you use. The wood carved by the engraving machine is not rough. It depends mainly on the quality of the wood. If the laser machine can't cut the wood, the laser will blacken the wood.
The best for you is the best.

A practical method for quickly solving the problem of stone engraving machine

The stone engraving machine is not engraved at the origin:
1. Whether the layout size of the file matches the machine.
2. Check if offset (OFFSET) is set and the layout is correct.
Cannot set the origin:
1. The size of the pattern in the file plus the set origin value is beyond the engraving range.
2. The OFFSET value plus the size of the pattern in the file is beyond the engraving range.

When the stone engraving machine starts to reset, the top bad limit switch:
1. The top of the jack is less than the limit switch, and it can be corrected.
2. The drive line is in poor contact and try to fix the drive line firmly.
3. The limit switch line is not connected, and it is connected.
4. The limit switch is damaged and a new limit switch is replaced.

The liquid display block does not display or display garbled characters when starting:
1. First check if the handle line is connected.
2. Connect the handle wire directly to the liquid display block to see if it is normal. If it is normal, the intermediate transfer cable is damaged and can be replaced.
3. Open the control cabinet to check if the interface board is loose.

The stone engraving machine spindle motor stops or slows down:
1. The operating voltage is unstable or overloaded, and a voltage regulator can be added.
2. Check if the middle line is connected and whether the thread is unsold.

Sometimes the offset is offset or offset to the right when the origin is set:
1. The limit switch fails. The limit switch is closed and popped up when the system returns to the system origin. Change the limit switch.
2. The drive line is loose. Try to fix it tightly.

When the engraving machine starts to reset, the X axis goes right or the Y axis goes forward or the Z axis goes down:
1. The limit switch is broken (the limit switch is always closed).
2. The drive line is broken, replace the drive line or separate the short circuit.
3. The drive board is broken and the drive board is replaced.